Magicar M871A Installation Guide

MAGICAR M871A Car alarm with two-way remote Installation guide 1

EN Options No. Function Button I Button II Button III Button IV 2-01 Trunk output time 0.5 sec 2 sec 3 sec 4 sec 2-02 Door lock impulse 0.8 se

EN and the pulse mode (Mode 2). Output - Lights Mode 1 – continuous Lights - flashing Mode 2 – pulse Lights Control Unit Relay contact bypassing

Entering valet mode with PIN code. 1. Armed. 2. By opening the door, the alarm will be triggered. Siren will chirp. 3. Within 3 sec turn the igniti

EN EN Programming of security code (1111-9999): 1. Ignition on. 2. Open the door. 3. Push the button on RPS sensor 10 times. At every single click,

Contact - locked Contact - unlocked yellow/black yellowyellow/white green/blackgreen/whitegreen NC1NC2COM1 NO1COM2 NO2 Original built-in control u

EN +12V 2 When Signal Light wire is connect to + - + - then Common wire - + MAGICAR 7 gray/black 6 orange 5 orange/black 4 red 3 red/black 2 green 1

16 - The car alarm system is designed for fitting into all kinds of cars with petrol and diesel engines with +12V volatge finished by a negative p

2 MAGICAR M871A Car alarm with two-way remote Installation guide

TABLE OF CONTENTS I. INTRODUCTION...

EN I. INTRODUCTION MAGICAR M871A is a safety device with the highest level of security. Thanks to the 2-way remote with pager you will be immediatel

EN WARNING! ¾ When installing a door contact, you must find an appropriate wire from the wire bundle of a car (it is important from the security poin

87 30 87a 85 86 line A line B +12V impuls (-) If you want to connect shortly two wires by (-) signal. E.g.: Mostly used for installing alarm gas rel

EN EN Starter-blocking connection: After cutting car starter lines, you have to connect lines to the relay outputs used to block the starter. 2 – gr

- LED indication CONNECTOR 9 - white - RPS sensor 8 - Shock sensor CONNECTOR 10 - red 3 – red - Power supply of +12 V 4 – yellow -

EN Note: • If you want to carry out any other changes, start the whole process over again. • If you hear a long beep, you are out of programming me